| |
PS-8 DN Intelligence
Sequence Power |
| |
 |
|
When the sequence
Power Switch on, You can use the computer to turn ON and
turn OFF any one of the power output promptly online ,So
to deal with the sudden fault of the equipment.
PS-8 DN is very convenient to be used when more one PS-8DN link.
You only need to connect the PS-8DN one by one with the
RS232 Data control cable. After connected , the
microchip in PS-8DN that can receive the command from
extend computer for intelligence control. For example,
10 bit A/D load power detect. If over load can auto cut
off this channel but not disturb other channel work
continue.10 LED indicat for each channel power volume.
Can connected 8 PS-8DN at the same time. |
|
|
|
|
| |
FEATURE：
1． 8Channel control with 16A relay, metch internation
standred.
2． 10 bit A/D convertor for load power detection.
3． Can be turned ON/OFF separately by sequence for
music system.
4． Over load warring and cut off the channel.
5． Can control every channel ON/OFF by standred RS232
serial port.
6． 10 LED display the power of load.
7． Can show and record work state of each channel .
8． Can connected 8 PS-8DN at the same time. |
|
LED STATE
INDICAT
USE 10 LED INDICATOR FOR ONE CHANNEL POWER
/10个发光二极管作为通道状态指示：
1． LED 1 FOR POWER SOURCE INDICATOR.
2． LED 2 FOR WORK INDICATION
3． LED 3 FOR OUTPUT POWER INDICATION (VALUME :1-250W)
4． LED 4 FOR OUTPUT POWER INDICATION (VALUME :251-500W)
5． LED 5 FOR OUTPUT POWER INDICATION (VALUME :501-750W)
6． LED 6 FOR OUTPUT POWER INDICATION (VALUME :751-1000W)
7． LED 7 FOR OUTPUT POWER INDICATION (VALUME :1001-1250W)
8． LED 8 FOR OUTPUT POWER INDICATION (VALUME :1251-1500W)
9． LED 9 FOR OUTPUT POWER INDICATION (VALUME :1501-1750W)
10． LED 10 FOR OUTPUT POWER INDICATION (VALUME :1751-2000W)
11． AT THE SAME TIME LED 10 IS FOR OVER LOAD INDICATION
WARNING. |
| |
|
|
|
| |
BACK SIDE
DECRIPTION
A. POWER OUTPUT CONNECTOR
B. POWER CORD
C. RS232 FEMALE SOCKET
D. RS232 MALE SOCKET
|
|
Description
1.8 channel power output with relay control from the
microchip.
2.Each channel 2200W 220V 50Hz.
3.Link allow up to eight PS-8DN device with RS232 data
cord.
4.Control voltage DC 12V for circuit in it.
5.Output connectors use U.S.A. standard three wire AC
connect.
6.Power source :220V 50Hz standard three wire,Grounded
wire is needed.
7.Dimension :485mmX190mmX50mm
8.Gross weight: 4 Kg
|
| |
|
|
|
| |
|
|
|
| |
|
|
|